Precor S3.45 manual Preparations, Required Tools, Installation Requirements

S3.45 Assembly and Maintenance Guide

2 Preparations

CAUTION: To set up this unit, you will need assistance. Do not attempt assembly by yourself.

You must review and follow the instructions in this guide. If you do not assemble and use the S3.45 according to these guidelines, you could void

the Pacific Fitness limited warranty (see back cover).

Required Tools

Tools that you must obtain before assembling the unit include:

❏⁹⁄₁₆-inch socket wrench

❏¾-inch socket wrench

❏⁹⁄₁₆-inch box-end wrench

❏¾-inch box-end wrench

❏Standard set of metric Allen wrenches

❏Two adjustable pliers or crescent wrenches

❏Measuring tape

❏Wire tie cutter (cuts plastic tie wraps)

❏Rubber mallet

❏Step stool

Installation Requirements

Follow these installation requirements when assembling the unit:

•Fill out and mail the limited warranty card. The warranty card is found on the back cover of this guide.

•Set up the S3.45 on a solid, flat surface. A smooth, flat surface under the unit helps keep it level. A level unit has fewer malfunctions.

•Provide ample space around the machine. Open space around the machine allows for easier access.

•Insert all bolts in the same direction. For aesthetic purposes, insert all the bolts in the same direction unless specified (in text or illustrations) to do otherwise.

•Leave room for adjustments. Tighten fasteners such as bolts, nuts, and screws so the unit is stable, but leave room for adjustments. Do not fully tighten fasteners until instructed in the assembly steps to do so.

Assembly Tips

•A 6-inch scale is provided at the bottom of every assembly instruction page. Use this scale to identify the correct size bolts and spacers. The head of a bolt is not used in measuring the length of a bolt.

To find out the length of a particular bolt, measure its shank (the long, narrow part beneath the head). Refer to the following diagram:

Bolt head

Bolt threads	To determine the
	length of a bolt,
	measure its shank.

Shank

•Read all the caution notes on each page before completing that step.

Note: A few of the bolts used to assemble the S3.45 are longer than 6 inches. You may want to use a measuring tape to accurately identify the correct sizes.

•Some pieces have extra holes that you will not use. Use only those holes indicated in the instructions and illustrations.

•While you may be able to assemble the S3.45 using the illustrations only, important safety notes and other tips are included in the text.

Preparations

page 6