Precor S3.45 manual Assemble Preacher Curl Weight Stack

S3.45 Assembly and Maintenance Guide

8.Assemble Preacher Curl Weight Stack

Before assembling the Weight Stacks, be certain the S3.45 is positioned in its permanent location.

A.Place two Guide Rods (from Box 1) into the large holes on the Preacher Curl side of the Main Base. The Guide Rods will be unstable until you complete step 5.

B.Place one Weight Cushion (from Box 1) on each Guide Rod and allow it to slide down to the top of the Main Base.

C.Apply one tube of lubricant to each Guide Rod. Avoid getting lubricant on your clothing or on other parts of the machine.

D.Add the five 15-lb weights, the ten 10-lb weights, and the five 5-lb weights. Note the tab location for weight stickers (you will attach the stickers later). Hold your finger over the plastic bushing in each weight to prevent the bushing from popping out.

CAUTION: The weights are heavy! Handle the weights carefully so as not to drop them or injure yourself. Pick up and place one weight at a time on the Guide Rods. Have someone hold the Guide Rods in place while you slide the weights on the stack.

E.Place the Cap Plate on the Guide Rods with the hole facing toward you. Allow it to slide onto the Weight Stack.

F.Insert the retainer pins of the Side Bracket into the Guide Rods. Attach the Side Bracket to the Top Frame using

one 2¾-inch bolt two washers one locknut Wrench tighten.

			Top Frame
	1 - 2¾" bolt
	F 2 - washers	Retainer		Side Bracket
	1 - locknut	Pins
				A Guide Rods (2)
	Rear Upright
				E Cap Plate
				D
	5 - 5-lb Weights
D	10 - 10-lb Weights
	5 - 15-lb Weights
					C
				B Weight
				Cushions (2)
	1	2	3	4	5	6

Step 8. Assemble Preacher Curl Weight Stack

page 17