Jensen CD1213 Liquid Crystal Display LCD, Display Disp, Auxiliary Input, Front Panel Release

CD1213

CONTROL to select from the following Beep Tone options:

•BEEP ALL: Beep is heard any time a button is pressed (function activated).

•BEEP 2ND: Beep is heard only when a secondary function is activated (press and hold).

•BEEP OFF: Beep is not heard.

Liquid Crystal Display (LCD)

The liquid crystal display (LCD) panel (8) displays the frequency, time and activated functions of the unit.

NOTE: After being subjected to cold temperatures, LCD panels may take longer to respond and visibility of the numbers on the LCD may decrease slightly. The LCD display will return to normal when the temperature increases to a normal range.

Display (DISP)

When the unit is on, the LCD automatically shows the display for the current source of operation.

When the unit is on, press the DISP button (9) to display the time of day. After five seconds, the display reverts to the current source.

Auxiliary Input

Lift the cover on the right side of the radio to reveal the AUX IN connector (16). Use the included 3.5mm media cable to connect a portable media device for playback through the vehicle sound system.

Front Panel Release

The front panel REL (release) button (10) releases the mechanism that holds the front panel to the chassis.

Detaching the Front Panel

To detach the front panel, first press the REL button (10) to release the left side of the panel. Next, grasp the released side and pull the panel off the chassis. After removing the front panel, store it in the supplied carrying case to protect it from dirt and damage.

REMOVE FRONT PANEL

1

2

Re-attaching the Front Panel

To re-attach the front panel, make sure the electrical terminals on the back of the panel are free of dust and dirt, as debris could cause intermittent operation or other malfunctions. Position the right side of the panel in place so that it is correctly engaged, and then lightly press the left side of the panel until the panel locks into place.

Reset Button

The reset button (26) is located on the front of the chassis and can only be accessed with the front panel removed. The reset circuitry protects the microprocessor circuitry. Since resetting the unit will erase the time and preset memories, it should only be activated upon initial installation after all wiring is complete, or if there is a malfunction of any of the switches on the unit. In these circumstances, pressing the reset button will clear the system and return the unit to normal operation.

RESET

26

4