Jensen JCR-263 instruction manual Power Source

POWER SOURCE

This AM/FM Dual Alarm Clock Radio operates on AC 240V~ 50Hz line power supply. 2 ‘AA’ (UM-3) alkaline batteries (Not included) are also required to retain the normal and alarm time settings in the event of a power outage.

AC OPERATION

Plug the AC Power Cord into the AC 240V~ 50Hz power source.

BACKUP BATTERY INSTALLATION

1.Open the Battery Compartment Door. Following the polarity diagram shown in the Battery Compartment, insert 2 new ‘AA’ size (UM-3) alkaline batteries.

2.Replace the Battery Compartment Door.

IMPORTANT: Be sure that the batteries are installed correctly. Wrong polarity may damage the unit.

BATTERY CARE

i.An Alkaline-type battery is recommended. For optimum performance, the batteries should be replaced every 6 months.

ii.If the unit is not to be used for an extended period of time, remove the batteries. An old or leaking battery can cause damage to the unit and will void the warranty.

iii.a) Do not mix old and new batteries.

b) Do not mix alkaline, standard (carbon-zinc) or rechargeable (Nickel-Cadmium) batteries.

iv.Do not try to recharge a battery that is not intended to be charged. The battery can overheat, rupture and leak. (Follow battery manufacturer’s directions).

v.Do not dispose of batteries in fire, batteries may leak or explode and cause personal injury.

POWER FAILURE INDICATOR

If no battery is installed or if the battery installed is weak or dead, the time and alarm settings will be lost if the power is interrupted. When the AC power is restored the Display will show “AM 12:00”. This indicates that the time displayed is incorrect and needs to be reset.

IMPORTANT:

After you have reset the time, be sure to reset your alarm settings as well.

3