Jensen JiMS-190 owner manual IPod Docking, You may control the playback of your iPod by

iPod® DOCKING

If the docking port will not be used for an extended period of time, it is recommended to cover the docking port by using the “Dock Cover” insert (included).

1.Use the iPod adaptor included in your iPod and insert it into the docking area. Your iPod can now be inserted into the docking port by placing the connector on the bottom of the iPod onto the connector in the docking bay.

Note: Please be careful when seating the iPod into the docking to avoid damaging the 30-pin connector on iPod or docking system.

2.Press the POWER On/Off button to switch on the docking system.

3.Press the FUNCTION button repeatedly until the indicator “iPod” shows on the display. The iPod® will start playing and charging automatically.

4.Select your desired EQ and play mode in your iPod®.

5.Press the VOL +/- button on the docking system to adjust your desired volume level

NOTE:The volume level cannot be adjusted by the volume control of your iPod® after being docked.

6.The iPod® is charging even during playback.

NOTE: The iPod will only charge in iPod, AUX, or power "OFF" modes.

7.To remove the iPod® from the unit, press and hold the PLAY/PAUSE button for three seconds to switch off the device and then gently remove it from the docking connector.

You may control the playback of your iPod® by:

-Press the PLAY/PAUSE button to pause or resume the iPod® playback;

-Press the iPod Skip/Search Forward or Backward button to skip to the next or previous song;

-Press and hold the iPod Skip/Search Forward or Backward button for fast-forwarding or fast-rewinding during playback.

8