VM9223
USING THE TFT MONITOR
Open/Close TFT Monitor
Open TFT Monitor
Press the OPEN ( 
) button (4) on the front panel or remote control to slide the monitor panel down to reveal the disc and SD card slots.
Close TFT Monitor
Press the OPEN ( 
) button (4) on the front panel or remote control to close the monitor panel.
Monitor Tilt Angle Adjustment
A known characteristic of LCD panels is the quality of the display in relationship to the viewing angle. The monitor angle can be adjusted for optimum viewing using one of the following methods:
Step by Step Angle Adjustment
Press the (
) or (
) button on the remote control (27, 26) to adjust the tilt angle of the screen one step at a time.
You can also adjust the tilt by pressing and holding the OPEN ( 
) button (4) on the front panel. Use the VOL
Continuous Angle Adjustment
Press and hold the (
) or (
) button on the remote control to adjust the tilt angle in a continuous motion.
Aspect Ratio
Press the WIDE button (28) on the remote control to adjust the aspect ratio as follows:
FULL
The entire screen is extended horizontally to the aspect ratio of 16 to
9.The extension ratio is the same at any point.
NORMAL
The conventional display image has a 4 to 3 ratio of horizontal to vertical, leaving a blank area on the right and left sides of the display.
STANDBY
Screen becomes black. Touch screen to resume.
Image Setting
Table 2 shows the video output mode for each playing source.
Table 2: Video Output Modes
Playing Source | Video Output Modes |
|
|
|
|
AM/FM TUNER | RGB Mode |
|
|
DVD | RGB Mode |
|
|
BT | RGB Mode |
|
|
AUX IN1 | CVBS Mode |
|
|
AUX IN2 | CVBS Mode |
|
|
NAV | CVBS Mode |
|
|
CAMERA | CVBS Mode |
|
|
*CVBS – Composite Video Baseband Signal
Parameter Adjustment Procedure
1.Enter Picture Quality Setting Mode:
Press the PIC button (24) on the remote control or the PIC button (3) on the monitor.
2.Select Item to Set:
Press the PIC button (3) on the control panel to select “BRIGHT” or “CONTRAST”.
3.Set Parameters:
Press the +/– buttons (15, 16) on the remote or press the
4.Exit Picture Quality Setting Mode:
Press the PIC button (24) on the remote control or the PIC button (3) on the monitor
Parking Brake Inhibit
When the pink "Parking" wire is connected to the vehicle Parking Brake circuit, the front TFT monitor will display video when the Parking Brake is engaged. (When the pink wire is grounded via the Parking Brake circuit, video will be displayed.)
5
