VM9413
USING THE TFT MONITOR
Open/Close TFT Monitor
Open TFT Monitor
Press the OPEN/CLOSE button (1) on the front panel or
press the ( 
) button (25) on the remote control to activate the mechanism that moves the display panel into the viewing position.
Close TFT Monitor
Press the OPEN/CLOSE button (1) on the front panel or
press the ( 
) button (25) on the remote control to load the display panel back into the compartment
TFT Monitor Auto Open
If “TFT Auto Open” is “on” when the unit is turned on, the monitor automatically moves to the viewing position.
If “TFT Auto Open” is ”off” when the unit is turned on, press
the OPEN button (1) or ( 
) button (25) on the remote control to move the monitor into the viewing position.
If “TFT Auto Open” is set to ”Manual”, the TFT will not close when the key is turned off.
Monitor Tilt Angle Adjustment
A known characteristic of LCD panels is the quality of the display in relationship to the viewing angle. The monitor angle can be adjusted for optimum viewing using one of the following methods.
Step by Step Angle Adjustment
Press the (
) or (
) button on the control panel (23, 24) or remote control (26, 27) to adjust the tilt angle of the screen one step at a time.
Continuous Angle Adjustment
Press and hold the (
) or ( 
) button on the control panel or remote control to adjust the tilt angle in a continuous motion.
Monitor Left/Right Angle Adjustment
To manually adjust the left/right angle of the TFT screen, follow these steps:
1.Make sure the TFT screen in “Out”. Press the OPEN button (1), if necessary.
Extender Mechanism | Extender Mechanism |
- Closed | - Fully Extended |
2
4
2.Locate the extender mechanism behind the screen.
3.Firmly grasp both sides of the screen near the bottom.
4.Gently pull on either the left or right side until the extender mechanism becomes fully extended.
Reverse Driving Use
If the
If the monitor is in display mode, the monitor automatically switches to CAMERA mode upon reverse driving. When the reverse driving stops, the monitor returns to its original input mode.
Aspect Ratio
Press the WIDE button (28) on the remote control or WIDE button (22) on the monitor to adjust the aspect ratio as follows (only active with video source):
CINEMA
The entire screen is extended horizontally to the aspect ratio of 16 to 9. The extension ratio is the same at any point.
NORMAL
The conventional display image has a 4 to 3 ratio of horizontal to vertical, leaving a blank area on the right and left sides of the display.
STANDBY
Screen becomes black. Touch screen to resume.
Image Setting
Table 2 shows the video output mode for each playing source.
Table 2: Video Output Modes
Playing Source | Video Output Modes |
|
|
|
|
RADIO | RGB Mode |
|
|
SAT | RGB Mode |
|
|
DISC | RGB Mode |
|
|
BT | RGB Mode |
|
|
AUX 1 | CVBS Mode |
|
|
AUX 2 | CVBS Mode |
|
|
NAV | RGB Mode |
|
|
CAMERA | CVBS Mode |
|
|
*CVBS – Composite Video Baseband Signal
7
