VM9413

Parameter Adjustment Procedure

1.Enter Picture Quality Setting Mode:

Press the PIC button on the remote control or press and hold the WIDE/PICTURE button (22) on the monitor.

2.Select Item to Set:

Use the up/down joystick buttons to select “BRIGHT” or “CONTRAST”.

3.Set Parameters:

Use the left/right joystick buttons to modify the settings.

4.Exit Picture Quality Setting Mode:

Press the PIC button on the remote control or the WIDE/ PICTURE button on the monitor.

Parking Brake Inhibit

When the pink "Parking" wire is connected to the vehicle Parking Brake circuit, the front TFT monitor will display video when the Parking Brake is engaged. (When the pink wire is grounded via the Parking Brake circuit, video will be displayed.)

Monitor Movement Mechanism

If an obstruction occurs in the monitor path, the following protective measurements can be executed to prevent damage to the mechanism or monitor:

Table 3: Monitor Protective Measures

Obstruction

Self

OPEN Button

Power

Protection

Pressed

Reconnected

 

 

 

 

 

 

 

 

 

Monitor load-

Unit stops at

Monitor fully

Monitor is auto-

ing out hori-

obstruction

extended hori-

matically

zontally

point

zontally

loaded into unit

Monitor load-

Unit stops at

Monitor fully

Monitor is auto-

ing in hori-

obstruction

extended hori-

matically

zontally

point

zontally

loaded into unit

Monitor load-

Unit stops at

Monitor swiv-

Monitor swiv-

ing out verti-

obstruction

els back to the

els back to the

cally

point

unit

unit

Monitor load-

Unit stops at

Monitor swiv-

Monitor swiv-

ing in verti-

obstruction

els back to the

els back to the

cally

point

unit

unit

After the protective procedure is executed, normal operation is resumed by pressing the OPEN button (1) or disconnecting and reconnecting the power.

8

Page 12
Image 12
Jensen VM9413 operation manual Parking Brake Inhibit, Monitor Movement Mechanism, Parameter Adjustment Procedure