DV352
Wiring
Power Connections | Audio/Video Connections |
1.GROUND WIRE (black) – Securely fasten the Ground wire to a grounded metal part of the car’s chassis. If you cannot find an existing bolt or screw to fasten it to, drill a hole in the metal and secure it with a screw. To ensure a good ground, remove any paint or grease from areas where the wire will contact the surface.
2.CONSTANT POWER WIRE (yellow) – Connect the 12V PLUS constant power wire to a live 12 volt wire in the vehicle. Before making a connection, check that the wire you intend to connect it to is always live, even when the car’s ignition is turned off. If a live wire is not found, route the wire to the car’s fuse block and connect it to a live circuit there.
3.ACC POWER WIRE (red) – Connect to a +12 volt circuit that is only live when the ignition is on. The best connection point is at the car’s fuse block at the “RADIO” or “ACCESSORY” identified terminals.
VIDEO 1 | AUDIO INPUT 1 | AUDIO OUT |
| VIDEO | VIDEO | |
INPUT | L | R | L | R | OUT1 | OUT2 |
DC12VIN DC12VOUT |
|
| ||||
+ |
|
|
|
|
|
|
|
|
| REMOTE |
|
|
|
| VIDEO 1 | AUDIO INPUT 1 | AUDIO OUT |
| VIDEO | VIDEO | |
| INPUT | L | R | L | R | OUT1 | OUT2 |
DC12VIN | DC12VOUT |
|
| ||||
| + |
|
|
|
|
|
|
|
|
|
| REMOTE |
|
|
|
|
|
|
| REMOTECONTROL RECEIVER |
|
|
|
Black
Yellow
3A |
Red
0.5A |
+
1Ground
Connect to ground terminal.
2Memory/Battery
Connect to battery or 12 volt power source that is always live. The radio will not work if this wire is not connected.
3Accessory/Ignition Connect to existing radio wire or radio fuse.
YELLOW | WHITE | RED | WHITE | RED | YELLOW | YELLOW |
NOTE: When replacing a fuse, be sure to use correct type and amperage to avoid damaging the DVD player. The DV352 uses one 3 amp and one 0.5 amp ACG fuse, located in the black filter boxes
5
