DV352
Installation
DIN Front-Mount Installation
1.Remove the transport screws.
2.Use the supplied release keys to remove the
|
|
|
|
|
|
| 2 |
MODE |
|
|
|
|
|
|
|
VOL | DVD / | CD / MP3 |
|
|
|
|
|
SEL |
| PLAYER |
|
|
|
| |
|
|
|
|
|
|
| |
|
|
| IR |
|
|
|
|
| MUTE |
|
|
|
|
|
|
|
|
| VIDEO | L |
|
| 1 |
|
|
| IN 2 | AUDIO IN 2 |
| ||
|
|
|
|
| R |
3.Install the
a.Install adapter if necessary (optional).
b.Install
c.Locate the series of bend tabs along the top, bottom and sides of the mounting sleeve. With the sleeve fully inserted into the dashboard opening, bend as many of the tabs outward as necessary to firmly secure the sleeve to the dashboard.
Install |
3c |
3a |
3b |
CAUTION! Be careful not to damage the car wiring.
4.Place the unit in front of the dashboard opening so the wiring can be brought through the mounting sleeve.
5.Complete wiring connections (see “Wiring” on page 5).
6.After completing the wiring connections, turn the unit on to confirm operation (ignition switch must be on). If unit does not operate, recheck all wiring until problem is corrected. Once the unit is properly operating, turn off the ignition switch and proceed with final mounting of the chassis.
7.Carefully slide the DVD player into the
NOTE: For proper operation of the CD/DVD player, the chassis must be mounted within 30° of horizontal. Make sure the unit is mounted within this limitation.
8.Attach one end of the perforated support strap (supplied) to the screw stud on the rear of the chassis using the hex nut provided. Fasten the other end of the perforated strap to a secure part of the dashboard either above or below the unit using the screw and hex nut provided.
Bend the strap to position it as necessary.
CAUTION! The rear of the unit must be supported with the strap to prevent damage to the dashboard from the weight of the unit or improper operation due to vibration.
9.Replace any items you removed from the dashboard.
DIN |
|
| 8 |
| 9 |
MODE | 5 |
| |
SEL |
|
| 4 |
3
