Quadra-Fire MTVERNON-AE-CSB C. Top Vent Adapter Installation, Mt. Vernon Pellet Stove AE

R

Mt. Vernon Pellet Stove (AE)

C. Top Vent Adapter Installation

3 to 3 inch Top Vent Adapter

3 to 6 inch Top Vent Offset Adapter

Installing the Top Vent Adapter

1.Put a layer of high temperature silicone on the 3 inch (76mm) exhaust outlet. Figure 19.1.

2. Slide the top vent adapter onto the rear exhaust	Align slot holes on the adapter
	to holes on the a k of the nit
outlet and adjust the assembly to a vertical position
until the top of the flue outlet is centered and is in
a level position. Figure 19.1.

3.Align slot on left of adapter with hole in the back of the unit and secure with screw. You may drill out the hole using #26 drill bit provided but only if needed.

Figure 19.2.

4.Install the 5 mounting screws, 3 on the left and 2

on the right. Figure 19.2

5.Drill 2 holes with #26 drill bit through the rear

exhaust outlet using the 2 holes already in the short	D. Rear Vent and Rear Vent to Top Vent
horizontal pipe in the top vent adapter as a guide.	Adapter Installation
Install the screws. Figure 19.2.

6. Install the vent pipe into the top vent adapter (be sure to silicone all joints). To use an existing 6 inch (152mm) vent system, install the 3 to 6 in (76- 152mm) offset adapter before installing vent pipe.

7. To clean top vent adapter, open clean-out cover and remove any debris build-up. Figure 19.2.

			Clean-Out Cover
			Figure 19.3 - Rear Vent Adapter
		3 in. to 6 in.	Clean-Out Cover
		Offset Adapter
	Drill Hole, 1	3 in. to 3 in. Top
		Vent Adapter
	on each side		Figure 19.4 - Rear to Top Vent Adapter - 90o
Silicone Rear
		Clean-Out
Exhaust Outlet			1. Put a layer of high temperature silicone on the 3 inch
		Cover
			(76mm) exhaust outlet. Figure 18.1.

Figure 19.1

2. Slide the adapter onto the rear exhaust outlet and adjust the assembly to the appropriate position.

3. Install the vent pipe into the adapter (be sure to silicone all joints)

September 1, 2008 7034-106E Page 19