Quadra-Fire MTVERNON-AE-CSB B. General Operating Information, C. Before Your First Fire

R

		Mt. Vernon Pellet Stove (AE)
B. General Operating Information	C. Before Your First Fire
	1. First, make sure your appliance has been properly
See Wall Control Thermostat Manual		installed and that all safety requirements have been met.
		Pay particular attention to the fire protection, venting and
for detailed operating instructions.		wall control thermostat installation instructions.
	2. Double check that the ash pan and firebox are empty
1. Wall Control Thermostat - Automatic Setting		and then close the front door.
		CAUTION
The appliance is like most modern furnaces; when the
wall control thermostat calls for heat, your appliance will
		Tip of thermocouple must be in contact with the inside
automatically light and deliver heat. When the room is up to
		end of the thermocouple cover.
temperature and the wall control is satisfied the appliance
		Missed ignitions can occur.
will shut down.
In the automatic setting the heat output level is controlled	D. Starting Your First Fire
by the wall control. Select “Automatic” on the AUTO/	1. Fuel Selection
MANUAL screen. Figure 23.1.
	To start your first fire, you must select the appropriate fuel on
	the FUEL SELECTION screen on the thermostat wall control
	to match the fuel you have chosen to burn.

Automatic

Manual

Off

Figure 23.1

2. Wall Control Thermostat - Manual Setting

When you select “Manual” on the AUTO/MANUAL screen the appliance will still automatically turn on and off according to the temperature setting. However, you will be able to manually control the heat output levels. Adjust the heat output levels by using the HEAT OUTPUT LEVEL screen.

If the proper fuel is not selected your appliance will not operate properly. For example, if you have selected wood pellets and you are burning corn, the appliance may not light, may go out or overfeed. Figure 23.3.

2. Comfort Level Selection

Once your fuel is selected, select the temperature at the desired setting on the SET COMFORT LEVEL screen.

Figure 23.4.

3. Automatic or Manual Setting

The automatic setting will control the heat output based on the comfort level selection. The manual setting allows you to manually control the heat output settings. See page 24,

Ignition Cycles.

NOTE: See the Wall Control Thermostat manual for detailed instructions.

Medium

Figure 23.2

3. Auto-Clean Firepot System

FUEL SELECTION

Corn

Utility Pellet

Softwood Pellet

Sunflower Seeds

Wheat

Hardwood Pellet

DONESELECT

Figure 23.3

Your appliance is equipped with an automatic firepot cleaning system that will change the frequency of cleaning based on the fuel being burned.

The auto-clean system will clean itself immediately on initial plug in. If there is a power outage, as soon as power is restored it will automatically clean itself.

Figure 23.4

September 1, 2008 7034-106E Page 23