R
Mt. Vernon Pellet Stove (AE)
H. Quick Start Guide
NOTICE: Any button pressed will turn on the backlight. Wall control will automati- cally revert back to the starting screen if there is no activity for 15 seconds; except for the “CONFIRM FUEL CHANGE” screen.
CHOOSING FUEL TYPE
R A |
| P |
Set at
MENU
1.At the starting screen, press “MENU” button once or twice until “MENU” screen appears.
MENU
Set Comfort Level
A to/ an al/ ff
Fuel Type
ser Settings
2.Highlight “FUEL TYPE” using the “UP/ DOWN” buttons to the right side of the display. Press “SELECT”.
F L S L C
Soft ood Pellet
S nflo er Seeds heat
ard ood Pellet
3.Scroll down and highlight “HARD- WOOD PELLET” or your fuel type.
4.Now press “SELECT” to choose new fuel
C F R | F | L C A |
Please empt | hopper | |
of old f | el t | pe and |
ens re fire o | is lean | |
Please refer to | ||
se tion | in man al | |
DONE |
|
|
5.Press “DONE” to confirm fuel change.
6.Press “DONE” twice or wait 15 sec- onds for starting screen to reap- pear.
7.Fill the hopper with fuel, and if the hopper was completely empty, or has run out of fuel, throw approximately 1/2 cup of pellets into the firepot.
8.Be sure the hopper lid and glass door are both closed.
|
| ttons |
|
| R A | P | Up |
Room |
| Set at |
|
|
| Down | |
Temp | MENU | HEAT OUTPUT | |
|
Function Buttons
Wall Control for Reference
TURNING ON APPLIANCE
R A |
| P |
Set at
MENU
1.At the starting screen, press “MENU”.
Set Comfort Level
A to/ an al/ ff
F el pe
ser Settings
2.Highlight “AUTO/MANUAL/OFF”. Press “SELECT”.
A
/
A
AL S
S
Atomati
an al ff
3.Highlight “MANUAL”. Press “SELECT”.
4.Press “DONE” twice or wait 15 seconds for starting screen to reappear.
CHOOSING TEMP UNIT:
°F or °C
R A |
| P |
Set at
MENU
1.At the starting screen, press “MENU” button once or twice until “MENU” screen appears.
Set Comfort Level
A to/ an al/ ff
F el pe
ser Settings
2.Highlight “USER SETTINGS” using the “UP/DOWN” buttons to the right side of the display. Press “SELECT”.
S R S S
emp nits F/C Flame eight Ad st
emp ifferential
2.Highlight “TEMP UNITS F/C” using the “UP/DOWN” buttons to the right side of the display. Press “SELECT”.
3.Press the “UP” or “DOWN” button to set desired temperature unit and press “SELECT”..
4.Press “DONE”. Press “DONE” again, or wait 15 seconds for starting screen to reappear.
Page 26 | September 1, 2008 |
