Quadra-Fire MTVERNON-AE-PMH owner manual Listing and Code Approvals, A. Appliance Certification

R

Mt. Vernon Pellet Stove (AE)

1 Listing and Code Approvals

A. Appliance Certification

Model	Mt. Vernon Pellet Stove AE
Laboratory	OMNI Test Laboratories, Inc.
Report No.	061-S-68-6
Type	Solid Fuel Room Heater/Pellet Type
Standard	ASTM E1509-04, ULC S627-00 and
	ULC/ORD-C1482-M1990 Room Heater
	Pellet Fuel Burning type and (UM) 84-
	HUD, Mobile Home Approved.
FCC	Complies with Part 15 of FCC Rules.
	Operation is subject to the following
	two conditions: (1) this device may not
	cause harmful interference, and (2) this
	device must accept any interference
	received, including interference that
	may cause undesired operation.

E. BTU & Efficiency Specifications

Emissions Rating:	EPA Compliance
*BTU Output:	14,620 - 60,200
Efficiency:	81.4% - 83.6%
Heating Capacity:	2,400 - 3,800 square feet depend-
	ing on heating zone
Hopper Capacity:	81 lbs
Fuels:	Pellets, Shelled Field Corn, Wheat
	and Black Sunflower Seeds
Shipping Weight:	429 lbs

*BTU output will vary, depending on the type of fuel you use in your stove. Consult your Quadra-Fire dealer for best results.

B. Mobile Home Approved

This appliance is approved for mobile home installations when not installed in a sleeping room and when an outside combustion air inlet is provided. The structural integrity of the mobile home floor, ceiling, and walls must be maintained. The appliance must be properly grounded to the frame of the mobile home and use only listed pellet vent Class “L” or “PL” connector pipe. A Quadra-Fire Outside Air Kit must be installed in a mobile home installation.

NOTE: Hearth & Home Technologies, manufacturer of this appliance, reserves the right to alter its products, their specifications and/or price without notice.

C. Glass Specifications

This appliance is equipped with 5mm ceramic glass. Replace glass only with 5mm ceramic glass. Please contact your dealer for replacement glass.

NOTE: This installation must conform with local codes. In the absence of local codes you must comply with the

ASTM E1509, ULC S627-00, (UM) 84-HUD and ULC/ ORD-C-1482.

D. Electrical Rating

115 VAC, 60 Hz, Start 5 Amps, Run 1.25 Amps

Page 4 7034-106E September 1, 2008