5.Attach a cross brace to the opposite end of the bed using three 5/16”x1” hex cap bolts, six 5/16” flat washers, and secure with three 5/16” hex nuts. Tighten the nut on the end of the bed first followed by the nuts on the sides.
6.Attach a leg to the cross brace using four 5/16”x3/4” carriage bolts, four 5/16” flat washers and four 5/16” hex nuts. Use a 12mm wrench to tighten. Repeat for other leg.
7.Attach the adjustable feet (A, Fig. 2) to the legs opposite of the motor, using the provided hardware.
8.Slide the axle (A, Fig. 3) through the legs. Place a large flat washer (B, Fig. 3) on both sides of the wheels and place on the axle. Secure wheels with two split pins (C, Fig. 3).
9.Carefully turn the saw onto its stand and adjust the feet so the bed is level.
10.Put the handle (A, Fig. 4) through holes in the stand legs opposite of the wheel assembly and secure with split pins.
6
