Jet Tools JSG-96 operating instructions Assembly

Assembly

CAUTION

￿Use care when lifting out of the shipping carton and moving to a final

location. Stand or bench must be stable enough to support weight of machine.

1.Move the sander to a workbench or one of JET’s optional stands. Bolt the unit firmly to hold in place.

JET’s closed stand uses four 3/8”x2-1/2” hex cap bolts, four 3/8” lock washers and four 3/8” flat washers provided with the stand.

JET’s open stand uses four 3/8”x3” hex cap bolts, four 3/8” lock washers and eight 3/8” flat washers, and four hex nuts provided with the stand.

2.Mount the sanding disc table assembly (A, Fig. 1) to the sander base. Insert the rod (B, Fig. 1) into the base and secure in place using the 5/16” handle (C, Fig. 1). The handle should tighten against the flat portion of the rod.

3.Mount the sanding belt table (A, Fig. 2) to the sander with two 5/16”x1-1/4” locking handles (B, Fig. 2), two 5/16” flat washers. The handle stud needs to go through the upper slot, and the guide pin (C, Fig. 2 & Figure 3) located on the sander should rest in the lower slot.

Note: The belt table can be removed and the disc table can be used in its place. There are two holes in the base, below the

sanding belt, that will accommodate the disc table’s support rod and locking handle.Machine is heavy!

8