13.To mount the table, remove pin and insert from the table (Fig. 13).
14.Rotate the table so that the saw blade will slide through the slot in the table. Then orient the table so the screws will slide into the holes on the trunnion support brac ket. Attach lock knobs to these screws (Fig. 13).
15.Replace pin and insert.
16.Connect the plugs of the motor cord and switch cord (Fig. 13a).
17.Transportation and handling may have caused some fasteners to loosen. Before operating, check all screws, bolts, and nuts to make sure they are snug. Operate machine only after reading the entire manual including blade tracking, blade guide adjustments, and safety rules.
Tilting the Table
WARNING
Unplug themachine from the power
source before making any repair or adjustment! Failure to comply may cause serious injury!
1. Loosen two lock knobs (Fig. 14).
2. Tilt table up to 45 degrees to the right or up to 10 degrees to the left, using the scale mounted to the trunnion.
3. Tighten two lock knobs (Fig.14).
Note: Table stop must be removed to tilt table to the left.
14
