Upper Blade Guide Handwheel (A, Fig. 3) - located on the upper right side of the saw. Turn
clockwise to raise the blade guide assembly. Turn
Work Lamp Switch (8, Fig. 3) - on top of lamp shade; turns lamp on and off.
Shear Lever (C, Fig. 3) - located on upper column.
UP position allows insertion of blade end into shear. Pull lever DOWN to cut blade.
Main Motor Start Switch (A, Fig. 4) - located on control panel. Depressto start bandsaw.
C
A
B
Main Motor Stop Switch (8, Fig. 4) - located on control panel. Depress to stop bandsaw.
Power Indicator Light (C, Fig. 4) - located on control panel. Indicates that power to the control panel is on.
Key Lock Switch (0, Fig. 4) - located on control panel. Turn to 12 o'clockposition and remove key to lock out power from the control panel. Insert key and turn to the three o'clockposition to turn on power to the control panel.
Emergency Stop Switch (E, Fig.4) - locatedon
the controlpanel. Pressto stopmachine.Turn90° to reset.
Digital Readout (F, Fig. 4) - located on the control panel. Indicates blade speed in feet per minute: Note: after the saw is first started or the speed has been changed, allow a least a minute for the readout to stabilize to the new setting.
Grinder Toggle Switch (A, Fig. 5) - located on blade welder panel found on column front. Flip switch up to start grinder; flip down to stop grinder.
Weld Button (8, Fig. 5) - located on blade welder panel found on column front. Depress and hold to start welding. Shuts off automatically whenweldis done. Release when weld is completed.
Anneal Button (C, Fig. 5) - located on blade welder
panel found on column front. Depress and hold to anneal blade, release to stop.
Blade Clamp Pressure Knob (0, Fig. 5) - located on bladewelderpanelfoundoncolumnfront. Sets pressurefor differentwidthblades.
Fig.3
F
C
A
D
B
E
Fig. 4
D
B
C
A
E
4 | Fig. 5 |
|
