Blade Clamps (E, Fig. 5) - located on blade welder
panel found on column front. DOWN position
allows insertion of blade into clamp. UP position locks blade.
Blade Tension Handwheel (A, Fig. 6) - located on underside of upper frame. Turn clockwise to tension blade;
Blade Tracking Handwheel (8 Fig.6) - locatedat the upper rear of the saw~ Turn clockwise to track blade toward front of the blade wheel Turn counter- clockwise to track blade toward rear of the blade wheel.
Table Tilt Mechanism - located under work table. To tilt table left or right, loosen two hex cap screws (A, Fig. 7) at rear of mechanism. To level table
front to back, loosen four hex cap screws (A, Fig. 8) on either side of mechanism.
Adjustments
All adjustments or repairs to the machine must be done with the power off and the machine disconnected from the power source. Failure to comply may cause serious injury!
Blade Tensioning
1.Raise upper blade guide by loosening lock knob (A, Fig. 9) and turning blade guide handwheel
(8)clockwise until it stops.
2.Apply finger pressure to the blade. Travel from
vertical should be approximately 3/8" each way.
3.To tighten blade, turn handwheel (A, Fig. 6) clockwise.
4.To loosen blade, turn handwheel counter- clockwise.
Fig. 6
Fig. 7
B
A
5
