DRAIN
The X‐32 is equipped with an automatic drain pump that will pump the drain water to a maximum height of 36" (0.9 meter). A 1" ID flexible drain hose is included to facilitate maintenance and servicing of the machine. It is important not to reduce the size of this hose. The drain should have a loop at the back of the dishwasher as per illustration below. The loop should be 36 inches (36”) above the floor and drop down into a drain pipe with an air gap. These instructions must be followed for proper dishwasher operation. It is normal for some water to remain in the wash tank after draining.
WATER INLET
A 3/4” NPT coupling is required with a maximum of 20 p.s.i. dynamic pressure, and a minimum of 18 p.s.i. . A water pressure regulator is required. The water pressure should be 20 p.s.i. Incoming water temperature must be 140º F ( 60º C). An easily accessible shut‐off valve is recommended ‐‐‐ making installation, service and repairs easier.
Flexible hoses must be used to make installation, servicing and maintenance easier.
Make sure that the water is free from calcium and hard water deposits. Water with a mineral contain of 6 grains or higher must have an on‐line water filtering system or some other type of water softening system. Build‐up of calcium and lime deposits in the washer may occur and servicing will be required on
a more frequent basis which will not be covered by the warranty.
