JL Audio f110 SYSTEM CONNECTION DIAGRAM 1 One Fathom to, Home Theater Receiver or, Page

PROCESSOR (BALANCED OUTPUTS) RECEIVER / PROCESSOR (UNBALANCED OUTPUTS)

PRE OUT

FRONT L REAR CENTER

OUTPUTS

OR

FRONT R REAR SUB

es with part 15 of the FCC rules. Operation is wing two conditions: (1) this device may not rference, and (2) this device must accept any ved, including interference that may cause n.

FATHOM REAR CONTROLS (MASTER)

WARNING! TURN OFF THE FATHOM AND ALL OTHER EQUIPMENT IN THE SYSTEM BEFORE MAKING OR CHANGING ANY CONNECTIONS!

SYSTEM CONNECTION DIAGRAM 1: One Fathom to

Home Theater Receiver or

Home Theater Preamp/Processor

Most home theater receivers and preamp/processors provide a single (mono) subwoofer output. When connecting a mono subwoofer output to your Fathom, you will only use the Fathom’s “Left or Mono” input.

Two connection types are available for connecting the Fathom to your home theater system: balanced (XLR or 1/4- inch TRS connector) and unbalanced (RCA-type connector). Balanced connections provide superior noise rejection and ensure proper grounding between components. If your receiver or processor has balanced outputs, we highly recommend that you use them.

In the connection diagram at left, balanced connections are shown as solid lines, unbalanced connections are shown dotted. You will only use one of these input connection methods (not both).

WARNING

Page 22 Fathom f110