SPECIAL CONSIDERATIONS FOR BUILT-IN INSTALLATIONS
Fathom subwoofers are designed to be
1)Allow 4 inches (10 cm) of clear space behind the Fathom’s amp panel for adequate cooling and connector clearance.
2)On all other sides (except the bottom), allow at least 2 inches (5 cm) clearance for adequate ventilation.
3)While the Fathom generally runs only warm during spirited operation, we do recommend that adequate heat vents are included in any custom cabinet which encloses the Fathom. A pair of 3 inch (7.5 cm) diameter vents near the bottom of the cabinet and near the top of the cabinet, will allow cool air to circulate over the amp panel of your Fathom subwoofer system keeping it cool and happy.
4)Your Fathom subwoofer is capable of moving substantial quantities of air. If the front of the Fathom is covered by a custom grille, the grille must have AT LEAST 108 square inches (700 sq.cm.) of vent area for the f113, AT LEAST 85 square inches (550 sq.cm.) for the f112, and AT LEAST 60 square inches (386 sq.cm.) for the f110. These areas are equal to the woofer cone area for each model and will ensure that the Fathom’s output is not choked by the custom cabinet.
Rear-view of cabinet install:
2 in. min.
VENT | VENT |
2 in. min.
VENT | VENT |
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Page 8 | Fathom f110 |