JL Audio SB-GM-SLVEXT/10W6v2 manual Stealthbox, Remove all contents from the rear floor area

Stealthbox®

I N S T A L L A T I O N G U I D E

for the

SB-GM-SLVEXT/10W6v2

(1999-2005 Chevrolet Silverado / GMC Sierra Extended Cab Trucks with full rear bench seating.)

(These instructions show for both enclo-

sures. These enclosures are

sold separately )

START

HERE

➔	6.5”	➔	6.5”	➔
	X		X
		6.0”	6.0”

Passenger’s Side

STEP 1: Remove all contents from the rear floor area.

Remove the paper backing and place the sup- plied wax square on the passenger’s side rear floor.The middle of the wax square needs to be placed 6.5” in front of the rear bulkhead and 6.0” away from the transmission tunnel.

Driver’s Side

STEP 1: Remove all contents from the rear floor area.

Remove the paper backing and place the sup- plied wax square on the driver’s side rear floor. The middle of the wax square needs to be placed 6.5” in front of the rear bulkhead and 6.0” away from the transmission tunnel.

STEP 3: Thread in the supplied socket cup set screw into the/each enclosure, leaving about 1/2” of the treads exposed.

Make sure that the cup end of the set screw is on the outside of the enclosure.

This Stealthbox is a product which requires professional installation skills and tools.

Please read this installation guide thor- oughly before beginning the project. It will guide you step by step through the installation. Several of the steps in this process may require two people to accomplish.

It is absolutely vital that the enclosure be properly mounted to the vehicle according to these instructions. Failure to mount the enclosure properly pres- ents two problems: 1) The sub-bass performance will suffer due to the movement of the enclosure caused by the force exerted by the woofer(s) and

2)A loose enclosure presents a serious safety hazard in the event of a collision or sudden deceleration.

Please enjoy your JL Audio Stealthbox responsibly.

➔

STEP 4: Place the/each enclosure into posi- tion and press down firmly.

Remove the/each enclosure.The wax square should have an impression of the socket cup set screw.

*CAUTION*
Before drilling, make sure that you are not going
to be drilling into any gas lines, brake lines, trans-
mission lines, electrical wiring, transfer case(4x4	➔
vehicles) or anything else that might cause a
➔ reduction in your weekly pay. Always wear eye
protection when drilling.

STEP 5: With the use of a 1/2” drill bit and drill. Drill out the floor at the impression on the wax square(s).

Continued on Next Page ➔

w w w . j l a u d i o . c o m SB - GM - SXT/10W6v2, JL AUDIO, Inc 2006 Pag e 1 Sheet SKU#011199 Revision 1/12/2006