JL Audio SB-POL-RGRRZR warranty Slampak, Sb-Pol-Rgrrzr, Installation G u i d e, SKU#94456 2009+

SB-POL-RGRRZR INSTR_SKU# 94456

Slampak

I n s t a l l a t i o n G u i d e

for the

SB-POL-RGRRZR

SKU#94456

2009+

If you choose to perform the installation yourself, it is absolutely vital that the Slampak® be properly mounted to the vehicle according to these instructions. Failure to mount the enclosure properly presents two problems:

1)The sub-bass performance will suffer due to the movement of the enclosure caused by the force exerted by the woofer(s).

2)A loose enclosure presents a serious safety hazard in the event of a collision or sudden deceleration.

INSTALLATION D I F F I C U LT Y :

2OUT OF

5

Estimated TIME:

1-2 HOURS

Thank you for choosing a JL Audio Slampak® for your side by side sport utility sound system. With proper installation, your new vehicle-specific enclosed subwoofer system will deliver years of listening pleasure.

We strongly recommend that you have your new Slampak® installed by your authorized JL Audio dealer. The installation professionals employed by your dealer have the necessary tools and experience to disassemble and reassemble your vehicle properly. Also, keep in mind that your warranty coverage extends to 2 years if your system is installed or approved by your authorized JL Audio dealer. If you prefer to perform your own installation, please read this installation guide completely

before beginning the process.

S T E P 1

Unpack the Slampak® mount the two brackets as shown

S T E P 2

There are two each of the pictured clamps, the ones with the short spacers (un-assembeled in the bag) go directly in front of the speakers, the ones with the long spacers (assembeled on the right) are installed from below, there are also locking pins that are not shown that are available and, can be put in place through the clamps to keep them in the locked positions. Make sure that all of the hardware on each of the clamps is snug so that when the arm is pushed flat, the rubber section of the clamp is squeezed and expands to hold the clamp in place.

S T E P 3

Line up the brackets with the existing holes as shown in the pictures at left and below.

Continued on Next Page