Building over a kitchen unit with door
Proper arrangements must be taken in designing the furniture unit, in order to avoid any contact with the bottom of the hob which can be heated when it is operated. The recommended solution is shown in diagram 3.
The panel fitted under the hob ("a") should be easily removable to allow easy access if technical assistance is needed. The space behind the kitchen unit ("b") can be used for connections.
Dimensions are given in mm.
3 |
Fitting the Hob into the Worktop
Carry out the building in of the hob as follows:
1.place the seals supplied with the hob on the front edge of the cut out.Then, place them at 86 mm from the side edges and at 10 mm from the rear edge, as shown in the diagram, taking care that the seals meet without overlapping.
2.Place the hob in the cut out, taking care that it is centred.
3.Fix the hob with the relevant fixing clamps, supplied with the injectors kit (see diagram).When the screws have been tightened, the excess seal can be removed.
The edge of the hob forms a double seal which prevents the ingress of liquids.
Seal |
15
