Instructions for the User
Operation
For easier lighting, proceed before putting a pan on the pan support.
)To light a burner:
zpush in the relevant control and turn it to maximum position.
zUpon ignition, keep the knob pushed down about 5 seconds. This will allow the "thermocouple" (Fig. 1 - letter D) to be heated and the safety device to be switched off, otherwise the gas supply would be interrupted.
zThen adjust the flame as required.
zIf the burner does not ignite, turn the control knob to zero, and try again.
If the burner accidentally goes out, turn the control knob to the “off” position and wait for at least 1 minute before trying to light the burner again.
Do not keep the control knob pressed for more than 15 seconds. If the burner does not light even after 15 seconds, release the control knob, turn it to the "off" position and wait for at least 1 minute before trying to light the burner again.
If you use a saucepan which is smaller than the recommended size, the flame will spread beyond the bottom of the vessel, causing the handle to overheat.
Take care when frying food in hot oil or fat, as the overheated splashes could easily ignite.
Burner | |
(Triple Crown) | |
| A |
| B |
| C |
| D |
A - Burner cap | Fig. 1 |
| |
B - Burner crown |
|
C - Ignition electrode | |
D |
|
18
