If the drying results are not satisfactory we suggest that you:
1.Fill up the rinse aid dispenser with rinse aid.
2.Activate the rinse aid dispenser.
3.Set the rinse aid dosage to position 2.
•The activation/deactivation of the rinse aid dispenser is only possible with the Multi tab function active.
Activation/deactivation of the rinse aid dispenser
1.Press the On/Off button. The dishwasher must be in setting mode.
2.Simultaneously press and hold function buttons B and C, until the lights of function buttons A, B and C start flashing.
3.Press function button B, the lights of function buttons A and C go off while the light of function button B continues to flash. The digital display shows the current setting.
rinse aid dispenser deactivated
rinse aid dispenser activated
4.To change the setting, press function button B again, the digital display shows the new setting
5.To memorize the operation, switch off the dishwasher by pressing the On/off button.
If you decide to revert back to the use of individual detergents we advise that you:
1.Deactivate the Multi tab function.
2.Fill up the salt container and the rinse aid dispenser again.
3.Adjust the water hardness setting to the highest setting and perform 1 normal washing programme without loading any dishes.
4.Adjust the water hardness setting according to the hardness of the water in your area.
5.Adjust the rinse aid dosage.
Select and start a washing programme
Select the washing programme and delay start with the door slightly opened. The start of the programme or the countdown of the delay start will occur only after the closure of the door. Until then it is possible to modify the settings.
1.Check that the baskets have been loaded correctly and that the spray arms are free to rotate.
2.Check that the water tap is opened.
3.Press the On/Off button. The dishwasher must be in setting mode.
4.Press the button corresponding to the required programme (see "Washing programmes" chart). Close the
20
