Manuals / John Lewis / Kitchen Appliance / Dishwasher

John Lewis JLDWS 907 instruction manual Adjusting the rinse aid dosage

Models: JLDWS 907

1 32

Page 14

Adjusting the rinse aid dosage

According to the finish and drying results obtained, adjust the dose of rinse aid by turning the dispenser's selector to the desired position (min-max): the amount of rinse aid dispensed is proportional to the selector position.

The dose is factory set in medium position. Increase the dose if there are drops of water or lime spots on the dishes after washing.

Reduce it if there are sticky whitish streaks on the dishes or a bluish film on glassware or knife blades.

Page 14

Image 14

John Lewis JLDWS 907 instruction manual Adjusting the rinse aid dosage

Contents

JLDWS Dishwasher Important safety information InstallationMaintenance and cleaning Child safetyGeneral safety ServiceCut off the cable and plug and dispose of them Environmental informationWhen a unit is no longer being used Pull the plug out of the socket For the user ContentsFor the installer 2 Technical data 6 InstallationRating plate Description of the applianceUpper basket Water hardness dialIndicator lights The control panelSetting mode Washing programmes Removing the dishes Changing the programmeEnd of cycle To cut down on detergent consumption! … and protect the environmentAdjusting the water When the dishwasher is first installedThe water softener hardness settingTo fill Adjusting the water softening systemFilling with dishwasher salt this is necessary only before filling with salt for the first timeFilling with rinse aid Adjusting the rinse aid dosage Daily use Loading cutlery and dishesLoading the lower basket Using the basketsLower basket Cutlery basket that the knife blades do not protrude from the basketUpper basket Loading the upper basketFill with detergent Adjusting the upper basketUse of detergent Multi tab function Detergent tabletsCleaning the spray arms Maintenance and cleaningCleaning the water intake filter Cleaning the spray arm, travelling versionInternal cleaning Cleaning the filtersExternal cleaning Frost precautionsE1 - Acquastop failure Something not workingE2 - Safety level E3 - Water heating malfunctionE6 - Water pump-out malfunction E4 - Water temperature monitoring malfunctionE5 - Water intake malfunction E7 - Turbine flow-regulator malfunctionIf the programme fails to start, check that Troubleshooting minor problemsIf the dishes are not being cleaned properly, check that If the dishes fail to dry or remain dull, check thatUnpacking Technical dataInstallation Fitting under a counterLevelling Water connections Water inlet connectionWater drain connection Fuse replacement Electrical connection0844 871 Repairs - after sales serviceSpare parts Subject to change without notice