Something not working
The dishwasher will not start or stops during operation. Certain problems are due to the lack of simple maintenance or oversights, which can be solved with the help of the indications described, without calling out an engineer.
Switch off the appliance and carry out the following suggested corrective actions.
Important! If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee.
Warning! Any operations performed on the appliance by unauthorised persons are not covered by the warranty and shall be paid for by the user.
If an alarm occurs the appliance interrupts the programme in progress and signals a fault.
•Alarms E1, E2, E3, E4, E8 and E9 interrupt the current programme immediately.
•The E5, E6 alarms interrupts the running programme once the cause is resolved, it will bring bach the execution of the programme.
•The alarm E7 is visualized at the end of the cycle that comes, however, brought to the end since the operation of the dishwasher is not harmed.
The dishwasher is capable of signalling a number of faults through the simultaneous illumination of several indicator lights, with the following meanings:
Light flashing
Light off
Light on
E1 - Acquastop failure
|
|
| |
Rinse | Quick | Economy | Auto Intensive |
hold | wash | 50° | 70° |
The
E2 - Safety level
|
|
| |
Rinse | Quick | Economy | Auto Intensive |
hold | wash | 50° | 70° |
The system which limits the water level inside the dishwasher has been tripped. Interrupt the programme and switch off the dishwasher. Switch the dishwasher back on, programme it again and start the washing cycle. If the problem persists, contact the
E3 - Water heating malfunction
|
|
| |
Rinse | Quick | Economy | Auto Intensive |
hold | wash | 50° | 70° |
To "reset" an alarm is necessary:
•Open and close the door, or turn off and on the machine. At this point is possible to programme the dishwasher again.
The water is not heated or the heating parameters are not correct. Repeat the washing programme; if the problem persists, contact the
23
