The appliance is supplied with a 13 amp plug fitted 2 . In the event of having to change the fuse in the plug supplied, a 13 amp ASTA approved (BS 1362) fuse must be used.
Warning! A cut off plug inserted into a 13 amp socket is a serious safety (shock) hazard. Ensure that it is disposed of safely.
Permanent connection
In the case of permanent connection it is necessary that you install a double pole switch between the appliance and the electricity supply (mains), with a minimum gap of 3mm between the switch contacts and of a type suitable for the required load in compliance with the current electrical regulations.
The switch must not break the green and yellow earth cable at any point.
Rear spacers
| 2 |
| 1 |
4 | 3 |
|
You can find the two spacers in the bag with documentation.
Do these steps to install the spacers:
1.Release the screw.
2.Engage the spacer below the screw.
3.Turn the spacer to the right position.
4. Tighten again the screws.
Levelling
When placing the appliance ensure that it stands level. This can be achieved by two adjustable feet at the bottom in front.
Removing the shelf holders
Your appliance is equipped with shelf retainers that make it possible to secure the shelves during transportation.
To remove them proceed as follows:
1.Move the shelf holders in the direction of the arrow (A).
2.Raise the shelf from the rear and push it forward until it is freed (B).
3.Remove the retainers (C).
18
