Unpacking
Warning !
Slide out the polythene bag containing the polystyrene block before using the appliance. Pull off adhesive strips from inside machine on top of drum. Keep all packaging away from children.
P1106 |
Should the appliance be moved, it must be transported vertically.
The appliance must not be installed behind a lockable door, a sliding door or a door with a hinge on the opposite side to that of the appliance.
Remove the rack
The drying rack offers the possibility of drying washable woollen fabrics and sports shoes. The drying rack does not turn with the tumble dryer drum. This enables the drying of woollen garments or sports shoes. When wet, the wool must be moved as little as possible because it tends to become matted. Sports shoes could damage the drum due to their weight.
1.Lift the rack out of the polystyrene protection used for transport and remove it from the tumble dryer drum.
2.Remove the pieces of polystyrene from the drum one at a time.
3.Remove the elastic band from the rack and the rack container.
Positioning |
It is recommended that, for your convenience, the machine is positioned close to your washing machine. The tumble dryer must be installed in a clean place, where dirt does not build up.
Air must be able to circulate freely all around the
appliance. It is important to ensure the air intake grills on the back of the dryer are not obstructed with any materials (e.g. paper, rags etc.). Obstructing the grills could be dangerous or at least seriously impair the efficiency of the tumble dryer.
To keep vibration and noise to a minimum when the dryer is in use, it should be placed on a firm, level surface. Once in its permanent operating position, check that the dryer is absolutely level with the aid of a spirit level. If it is not, raise or lower the feet until it is.
The feet must never be removed.
Do not restrict the floor clearance through deep- pile carpets, strips of wood or similar. This might cause heat
Important
The hot air emitted by the tumble dryer can reach temperatures of up to 60°C. The appliance must be sited in a well ventilated room but not be installed on floors which are not resistant to high temperatures.
When operating the tumble dryer, the room temperature must not be lower than +5°C and higher than +35°C, as it may affect the performance of the appliance.
Stacking kit (optional accessory)
It should be possible to stack your new dryer on top of a front loading washing machine with a cover’s depth between 48 and 60 cm.
Read carefully the instructions supplied with the stacking kit.
Please contact your local John Lewis branch for further advice.
P1148
Door reversal
To make it easier to load or unload the laundry the door can be reversed.
Warning!
The door must only be reversed by an authorised 
service engineer.
Please contact your nearest John Lewis branch who will give you details of your local Service Force Centre. The engineer will carry out the door reversal at your cost.
6
