When the refrigerator is first installed
General information
This appliance is designed for domestic use only.
To ensure correct operation, the appliance should be located where the ambient temperature of between
Using the Appliance
Before Use
Remove all packaging and adhesive tape.
Wash the inside of the appliance with lukewarm water and bicarbonate of soda (5 ml to 0,5 litre of water). Do not use soap or detergent as the smell may linger. Dry the appliance thoroughly.
perfumed cleaning products, wax polishes or products containing alcohol.
)To Start the Appliance
1.Allow the appliance to stand for 2 hrs after installation.
2. Plug in the appliance and switch on at the mains supply.
3.Turn the thermostat control to the required setting. A setting of 3 is usually suitable for normal operation (see thermostat control).
4. Leave the appliance for approximately 4 hours for the correct temperature to be reached before placing food inside.
Thermostat Control
The thermostat control knob situated inside the refrigerator regulates the temperature of the larder compartment. Thermostat control is marked from
Position | 0 | - | Off |
Position | 1 | - | minimum coldness |
Position | 5 | - | maximum coldness |
10
