John Lewis JLWD1404 Option buttons, Automatic Dry button, Time dry button, Delay start button

4 “Option” buttons

Depending on the programme, different functions can be combined. These must be selected after choosing the desired programme and before depressing the “”Start/Pause” button.

When these buttons are pressed, the corresponding pilot lights illuminate. When they are pressed again, the pilot lights go out.

If an incorrect option is selected, the pilot lights flash for about 2 seconds and the message Err is displayed. Press these buttons to select the following options:

•“Prewash”: select this option if you wish your laundry to be prewashed before the main wash (not available for Wool and “30 Minute wash” and not recommended with the programme Duvet 40°).

The prewash cycle ends with a short spin at 650 rpm in programmes for cotton and synthetic fabrics, whereas in the programme for delicate fabrics the water is only drained. This option can be selected for heavily soiled laundry.

•“Quick”: select this option for laundry that is only slightly soiled in order to obtain a good wash result in a short time.

This option is not available with the Wool programmes, the Energy saving programmes “Economy” and “30 Minute wash”.

The washing time will be reduced according to the type of fabric and the selected temperature.

•“Extra rinse”: this option can be selected with all programmes, except the wool programmes and “30 Minute wash”. The machine performs 4 rinses instead of 3.

This option is recommended for people who are allergic to detergents, and areas where the water is very soft.

5 “Automatic Dry” button

This button allows you to choose the required degree of drying for cottons and synthetics:

-Extra dry (only for cottons)

-Store dry (cottons and synthetics)

-Iron dry (only for cottons)

The drying time is automatically adjusted by the machine: the laundry will be dried to the selected degree of dryness.

6 “ Time dry” button

If you wish to carry out a timed programme instead of an electronic programme push the button until the drying time you want appears in the display according to the fabrics (cotton or synthetics) you have to dry.

For Cottons you can select a drying time from 10 minutes to 130 minutes.

For Synthetics you can select a time from 10 minutes to 100 minutes.

7 “Delay start” button

This button makes it possible to delay the starting of the programme by up to 24 hours. The delay you have selected is shown on the display for about 3 seconds; afterwards, the duration of the programme reappears. You must select this option after you have set the programme and before you press the Start/Pause button.

The time value shown on the display will decrease by one unit every hour.

You can change the delay time at any moment, before you press the “Start/Pause” button.

If you have already pressed the “Start/Pause” button, and you wish to change or cancel the delay time, proceed as follows:

•set the machine to PAUSE by pressing the “Start/Pause” button;

•press the “Delay start” button until the display shows the desired delay time or

•press the “Delay start” button once, to erase the delay time. The display will indicate “0 h”.

•press the “Start/Pause” button again.

Important!

The door will be locked throughout the delay time. If you need to open the door, you must first set the washer-dryer to Pause by pressing the Start/Pause button. After you have closed the door, press the Start/Pause button again.

8 “Start/Pause” button

This button has three functions:

•Start: after you have selected the desired programme and options, press this button to start the washer- dryer. The light above the button will stop flashing and remain lit.

If you have selected a delay time, the countdown will begin and will be shown on the display.

7