English---7
115304126 Rev.2 7/15/10
GENERAL SAFETY PRECAUTIONS
Stop switch
Make sure the engine stops when you push
andhold t he stop switch.
Cuttingattachment guard
This guard is intended to prevent loose
objects from being thrown towards the
operator.The guard als o protects the
operator from accidental contact with the
cutting attachment.
Check that the guard is undamaged and not
cracked. Replace the guard if it has been
exposed to impact or is cracked.
Always use the recommended guard for the
cutting attachment you are using. Seethe
“Technicaldata” sec tion.
WARNING: Never use a cutting
attachmentw ithoutan approved
guard. See the section on “Technical
data”. If an incorrect or faulty guard
is fitted this can cause serious
personal injury.
WARNING: Overexposure to
vibration can lead to circulatory
damage or nervedamage in people
who have impaired circulation.
Contact your doctor if you experi-
ence symptomsof overexposure to
vibration. Such symptoms include
numbness,loss of feeling, tingling,
pricking, pain, loss of strength,
changes inskin color or condition.
These symptomsnormally appear
in the fingers, handsor w rists.The
risk increases at low temperatures.
Muffler
The muffleris designedto reduce the noise
level and to direct the exhaust gases away
from the operator.
CAUTION! Muffleris fittedwith a catalytic
convertic designed to reduce harmful ex-
haust gases.
Harness quickrelease
There is an easily accessible, harness
quick release fitted at the front in case of an
emergency that requires you to free your-
self from the machine and harness.
See instructions under the heading Adjust-
ingt he harness.
Check that the harness straps are correctly
positioned. Once the harness and machine
have been adjusted, check that the harness
quick release works correctly.
Use of incorrectly wound trimmer line or an
incorrect cutting attachment increases the
level of vibration.
See instructions under the heading Start.
Start the machine and apply full throttle.
Release the throttle and check that the
cutting attachment stops and remains at a
standstill. If the cutting attachment rotates
with the throttle in the idle position then the
carburettor idle setting must be checked.
See instructions under the heading
Maintenance.