KEY to Symbols, Key to symbols | Jonsered CS 2147 specification

KEY TO SYMBOLS

Key to symbols

WARNING! Chain saws can be dangerous! Careless or incorrect use can result in serious or fatal injury to the operator or others.

Please read the operator’s manual carefully and make sure you understand the instructions before using the machine.

Always wear:

•Approved protective helmet

•Approved hearing protection

•Protective goggles or a visor

This product is in accordance with applicable EC directives.

Noise emission to the environment according to the European Community’s Directive. The machine’s emission is speciﬁed in chapter Technical data and on label.

Switch off the engine by moving the stop switch to the STOP position before carrying out any checks or maintenance.

Always wear approved protective gloves.

Regular cleaning is required.

Visual check.

Protective goggles or a visor must be worn.

Refuelling.

Filling with oil and adjusting oil ﬂow.

If your machine bears this symbol it is equipped with carburettor heating.

2 – English

If your machine bears this symbol it is equipped with a catalytic converter.

Other symbols/decals on the machine refer to special certiﬁcation requirements for certain markets.

Image 2

Jonsered CS 2147 manual KEY to Symbols, Key to symbols

Contents

Operator′s manual KEY to Symbols Key to symbols Contents Personal protective equipment Safety InstructionsMachine′s safety equipment Chain brake and hand guard Chain catcher Stop switchThrottle lock Right hand guard Checking the hand guard MufﬂerChecking brake band wear Throttle lock Checking the inertia brake releaseChecking the brake trigger Chain catcher General rules Stop switchCutting equipment Vibration damping system Chain Cutting equipment designed to minimise kickbackBar Some terms that describe the bar and chain With a badly sharpened chain Sharpening your chain and adjusting raker clearanceGeneral information on sharpening cutting teeth Tensioning the chain General advice on setting raker clearanceSetting the raker clearance Sharpening cutting teeth Filling with chain oil Lubricating cutting equipmentChain oil Checking chain lubrication Checking wear on cutting equipment Lubricating the bar tip sprocketNeedle bearing lubrication Chain drive sprocket Do not let go of the handles How to avoid kickbackWhat is kickback? General safety precautions Fuel safety Starting Transport and storage Basic safety rulesGeneral working instructions Terms Basic cutting techniqueGeneral Cutting Safe distance Tree felling techniqueLimbing Felling direction Directional cuts Clearing the trunk and preparing your retreatFelling Felling cut Cutting the trunk into logs Freeing a trapped tree General adviceFreeing a tree that has fallen badly Cutting trees and branches that are in tension What is WHAT? What is what on the chain saw? Fitting a spike bumper AssemblyFitting the bar and chain Working with the chain Following applies to chain saws with catalytic converters Fuel HandlingFuel Chain oil Fuelling Cold engine Starting and StoppingStarting and stopping Warm engine Stopping Maintenance Carburettor Starter Fine adjustment of the idle speed TCorrectly adjusted carburettor High speed jet H Tensioning the recoil spring Air ﬁlterSpark plug Changing a broken recoil spring Mufﬂer Adjustment of the oil pumpWhen making adjustments Needle bearing lubrication Electrical carburettor heating CS 2147WH, CS 2152WH Centrifugal cleaning TurboHeated handles CS 2147W, CS 2152W Winter use Monthly maintenance Daily maintenanceWeekly maintenance Below you will ﬁnd some general maintenance instructions Technical Data Technical data Bar and chain combinations Cispr 121997, EN608 EC-declaration of conformityApplies to Europe only Page 1088890-26