KEY to Symbols, Key to symbols | Jonsered CS 2156 specification

KEY TO SYMBOLS

Key to symbols

WARNING! Chain saws can be dangerous! Careless or incorrect use can result in serious or fatal injury to the operator or others.

Please read the operator’s manual carefully and make sure you understand the instructions before using the machine.

Always wear:

•Approved protective helmet

•Approved hearing protection

•Protective goggles or a visor

Both of the operator′s hands must be used to operate the chain saw. Please see page 30 in your "Chain saw operator′s safety manual".

Never operate a chain saw holding it with one hand only. Please see page 30 in your "Chain saw operator′s safety manual".

Contact of the guide bar tip with any object should be avoided. Please see pages 12-21 in your "Chain saw operator′s safety manual".

Tip contact may cause the guide bar to move suddenly upward and backward, which may cause serious injury. Please see pages 12- 21 in your "Chain saw operator′s safety manual".

Switch off the engine by moving the stop switch to the STOP position before carrying out any checks or maintenance.

Always wear approved protective gloves.

Regular cleaning is required.

Visual check.

Protective goggles or a visor must be worn.

2 – English

Refuelling.

Filling with oil and adjusting oil ﬂow.

If your machine bears this symbol it is equipped with carburettor heating.

If your machine bears this symbol it is equipped with a catalytic converter.

Other symbols/decals on the machine refer to special certiﬁcation requirements for certain markets.

Image 2

Jonsered CS 2156 manual KEY to Symbols, Key to symbols

Contents

EPA KEY to Symbols Key to symbols Contents EPA Personal protective equipment Safety InstructionsMachine′s safety equipment Chain brake and front hand guard Chain catcher Stop switchThrottle lock Right hand guard Checking the front hand guard MufﬂerChecking brake band wear Throttle lock Checking the inertia brake releaseChecking the brake trigger Chain catcher General rules Stop switchCutting equipment Vibration damping system Chain Cutting equipment designed to minimise kickbackBar Some terms that describe the bar and chain Sharpening cutting teeth Sharpening your chain and adjusting raker clearanceGeneral information on sharpening cutting teeth With a badly sharpened chain Tensioning the chain General advice on setting raker clearanceSetting the raker clearance If the raker clearance is too large Filling with chain oil Lubricating cutting equipmentChain oil Checking chain lubrication Chain drive sprocket Needle bearing lubricationChecking wear on cutting equipment Do not let go of the handles How to avoid kickbackWhat is kickback? General safety precautions Starting General working instructions Fuel safetyBasic safety rules Transport and storage Terms Basic cutting techniqueGeneral Cutting Limbing Felling direction Tree felling techniqueSafe distance Clearing the trunk and preparing your retreat Felling cut Cutting the trunk into logs General adviceFreeing a tree that has fallen badly Freeing a trapped tree What is WHAT? What is what on the chain saw? Assembly Fitting the bar and chain Following applies to chain saws with catalytic converters Fuel HandlingFuel Chain oil Fuelling Cold engine Starting and StoppingStarting and stopping Warm engine Stopping Maintenance Carburettor Changing a broken or worn starter cord Correctly adjusted carburettorStarter Tensioning the recoil spring Mufﬂer Air ﬁlterSpark plug Fitting the starter When making adjustments Adjustment of the oil pumpCentrifugal cleaning Turbo Needle bearing lubrication Heated handles CS 2156W, CS 2159W Temperature 0 C 32 F or colderTemperature -5C 23 F or colder Electrical carburettor heating CS 2156WH, CS 2159WH Below you will ﬁnd some general maintenance instructions Daily maintenance Weekly maintenanceMonthly maintenance Technical Data Technical data 063/1,6 mm 22BP Bar Length Pitch, inch Max nose Chain Inches Radius050/1,3 mm 20BP Federal Emission Control Warranty Statement Your Warranty Rights and Obligations 1088891-95