Safety Instructions, Machine′s safety equipment | Jonsered CS 2156

SAFETY INSTRUCTIONS

Personal protective equipment

WARNING! Most chain saw accidents

!happen when the chain touches the operator.

You must use approved personal protective equipment whenever you use the machine. Personal protective equipment cannot eliminate the risk of injury but it will reduce the degree of injury if an accident does happen. Ask your dealer for help in choosing the right equipment.

WARNING! Long or continuous exposure to

!high noise levels may cause permanent hearing impairment. Always wear approved hearing protection when operating a chain saw.

•Protective helmet

•Hearing protection

•Protective goggles or a visor

•Gloves with saw protection

•Protective trousers with saw protection

•Boots with saw protection, steel toe-cap and non-slip sole

Generally clothes should be close-ﬁtting without restricting your freedom of movement.

•Always have a ﬁrst aid kit nearby.

Machine′s safety equipment

This section describes the machine′s safety equipment, its purpose, and how checks and maintenance should be carried out to ensure that it operates correctly. See the ”What is what?” section to locate where this equipment is positioned on your machine.

WARNING! Never use a machine that has

!faulty safety equipment! Carry out the inspection, maintenance and service routines listed in this section.

•Chain brake and front hand guard

•Throttle lock

•Chain catcher

•Right hand guard

•Vibration damping system

•Stop switch

•Mufﬂer

•Cutting equipment. See instructions under the heading Cutting equipment.

English – 5

Image 5

Jonsered CS 2156 manual Safety Instructions, Personal protective equipment, Machine′s safety equipment

Contents

EPA Key to symbols KEY to Symbols Contents EPA Personal protective equipment Safety InstructionsMachine′s safety equipment Chain brake and front hand guard Throttle lock Stop switchChain catcher Right hand guard Checking the front hand guard MufﬂerChecking brake band wear Checking the brake trigger Checking the inertia brake releaseThrottle lock Chain catcher Cutting equipment Stop switchGeneral rules Vibration damping system Bar Cutting equipment designed to minimise kickbackChain Some terms that describe the bar and chain General information on sharpening cutting teeth Sharpening your chain and adjusting raker clearanceSharpening cutting teeth With a badly sharpened chain Setting the raker clearance General advice on setting raker clearanceTensioning the chain If the raker clearance is too large Chain oil Lubricating cutting equipmentFilling with chain oil Checking chain lubrication Chain drive sprocket Needle bearing lubricationChecking wear on cutting equipment Do not let go of the handles How to avoid kickbackWhat is kickback? Starting General safety precautions Basic safety rules Fuel safetyGeneral working instructions Transport and storage Terms Basic cutting techniqueGeneral Limbing Cutting Safe distance Tree felling techniqueFelling direction Clearing the trunk and preparing your retreat Felling cut Freeing a tree that has fallen badly General adviceCutting the trunk into logs Freeing a trapped tree What is what on the chain saw? What is WHAT? Fitting the bar and chain Assembly Following applies to chain saws with catalytic converters Fuel HandlingFuel Fuelling Chain oil Starting and stopping Starting and StoppingCold engine Warm engine Stopping Carburettor Maintenance Starter Correctly adjusted carburettorChanging a broken or worn starter cord Tensioning the recoil spring Spark plug Air ﬁlterMufﬂer Fitting the starter Centrifugal cleaning Turbo Adjustment of the oil pumpWhen making adjustments Needle bearing lubrication Temperature -5C 23 F or colder Temperature 0 C 32 F or colderHeated handles CS 2156W, CS 2159W Electrical carburettor heating CS 2156WH, CS 2159WH Below you will ﬁnd some general maintenance instructions Daily maintenance Weekly maintenanceMonthly maintenance Technical data Technical Data 063/1,6 mm 22BP Bar Length Pitch, inch Max nose Chain Inches Radius050/1,3 mm 20BP Your Warranty Rights and Obligations Federal Emission Control Warranty Statement 1088891-95