Throttle lock, Chain catcher, Right hand guard | Jonsered CS 2171WH

SAFETY INSTRUCTIONS

Grasp the chain saw ﬁrmly, wrapping your ﬁngers and thumbs around the handles.

Apply full throttle and activate the chain brake by tilting your left wrist forward onto the front hand guard. Do not let go of the front handle. The chain should stop immediately.

Throttle lock

•Make sure the throttle control is locked at the idle setting when the throttle lock is released.

•Press the throttle lock and make sure it returns to its original position when you release it.

•Check that the throttle control and throttle lock move freely and that the return springs work properly.

•Start the chain saw and apply full throttle. Release the throttle control and check that the chain stops and remains stationary. If the chain rotates when the throttle control is in the idle position you should check the carburettor idle adjustment.

Chain catcher

Check that the chain catcher is not damaged and is ﬁrmly attached to the body of the chain saw.

Right hand guard

Check that the right hand guard is not damaged and that there are no visible defects, such as cracks.

Vibration damping system

Regularly check the vibration damping units for cracks or deformation.

Make sure the vibration damping units are securely attached to the engine unit and handle unit.

Stop switch

Start the engine and make sure the engine stops when you move the stop switch to the stop setting.

8 – English

Image 8

Jonsered CS 2171WH manual Throttle lock, Chain catcher, Right hand guard, Vibration damping system, Stop switch

Contents

Operator´s manual KEY to Symbols Key to symbols Contents Personal protective equipment Safety InstructionsMachine′s safety equipment Chain brake and front hand guard Stop switch Throttle lockChain catcher Right hand guard Mufﬂer Checking brake band wearChecking the front hand guard Checking the inertia brake release Stop switch Throttle lockChain catcher Right hand guard Cutting equipment General rulesCutting equipment designed to minimise kickback Mufﬂer Sharpening your chain and adjusting raker clearance ChainSome terms that describe the bar and chain General information on sharpening cutting teeth Sharpening cutting teeth General advice on setting raker clearance Setting the raker clearanceTensioning the chain If the raker clearance is too large Lubricating cutting equipment How to avoid kickback What is kickback?Checking wear on cutting equipment Chain drive sprocket Do not let go of the handles General safety precautions Starting Fuel safety Basic safety rulesGeneral working instructions Transport and storage Terms Basic cutting techniqueGeneral Cutting Limbing Tree felling technique Safe distanceFelling direction Clearing the trunk and preparing your retreat Cutting the trunk into logs Felling cut General advice Freeing a tree that has fallen badlyFreeing a trapped tree Cutting trees and branches that are in tension What is WHAT? What is what on the chain saw? Assembly Fitting the bar and chainFitting a spike bumper Working with the chain Fuel Handling FuelPetrol Two-stroke oil Min 3 m 10ft Chain oilFuelling Starting and Stopping Starting and stoppingCold engine Warm engine Stopping Carburettor with movement limiters MaintenanceCarburettor adjustment Fine adjustment of the idle speed T Correctly adjusted carburettorCarburettor without movement limiters Low speed jet L Recommended engine speeds are as follows Idle speed, rpm Starter Air ﬁlter Adjustment of the oil pump When making adjustmentsSpark plug Mufﬂer Centrifugal cleaning Turbo Cooling systemHeated handles Electrical carburettor heating Below you will ﬁnd some general maintenance instructions Daily maintenance Weekly maintenanceMonthly maintenance Technical Data Technical data Length, inches Pitch, inch Max. number of teeth on Bar and chain combinationsBar Chain EN292-2, Cispr 121997, EN608 EC-declaration of conformityApplies to Europe only Page 1088935-26 ´z*xT¶6U¨ ´z*xT¶6U¨