KEY to Symbols, Key to symbols | Jonsered CS 2171WH specification

KEY TO SYMBOLS

Key to symbols

WARNING! Chain saws can be dangerous! Careless or incorrect use can result in serious or fatal injury to the operator or others.

Please read the operator’s manual carefully and make sure you understand the instructions before using the machine.

Always wear:

• Approved protective helmet

• Approved hearing protection

• Protective goggles or a visor

This product is in accordance with applicable

EC directives.

Noise emission to the environment according to the European Community’s Directive. The machine’s emission is speciﬁed in chapter Technical data and on label.

Switch off the engine by moving the stop switch to the STOP position before carrying out any checks or maintenance.

Always wear approved protective gloves.

Regular cleaning is required.

Visual check.

Protective goggles or a visor must be worn.

Refuelling.

Filling with oil and adjusting oil ﬂow.

Other symbols/decals on the machine refer to special certiﬁcation requirements for certain markets.

2 – English

Image 2

Jonsered CS 2171WH manual KEY to Symbols, Key to symbols

Contents

Operator´s manual KEY to Symbols Key to symbols Contents Personal protective equipment Safety InstructionsMachine′s safety equipment Chain brake and front hand guard Chain catcher Stop switchThrottle lock Right hand guard Checking the front hand guard MufﬂerChecking brake band wear Checking the inertia brake release Chain catcher Stop switchThrottle lock Right hand guard Cutting equipment designed to minimise kickback Cutting equipmentGeneral rules Mufﬂer Some terms that describe the bar and chain Sharpening your chain and adjusting raker clearanceChain General information on sharpening cutting teeth Sharpening cutting teeth Tensioning the chain General advice on setting raker clearanceSetting the raker clearance If the raker clearance is too large Lubricating cutting equipment Checking wear on cutting equipment How to avoid kickbackWhat is kickback? Chain drive sprocket Do not let go of the handles General safety precautions Starting General working instructions Fuel safetyBasic safety rules Transport and storage Terms Basic cutting techniqueGeneral Cutting Limbing Felling direction Tree felling techniqueSafe distance Clearing the trunk and preparing your retreat Cutting the trunk into logs Felling cut Freeing a trapped tree General adviceFreeing a tree that has fallen badly Cutting trees and branches that are in tension What is WHAT? What is what on the chain saw? Fitting a spike bumper AssemblyFitting the bar and chain Working with the chain Petrol Fuel HandlingFuel Two-stroke oil Min 3 m 10ft Chain oilFuelling Cold engine Starting and StoppingStarting and stopping Warm engine Stopping Carburettor with movement limiters MaintenanceCarburettor adjustment Carburettor without movement limiters Fine adjustment of the idle speed TCorrectly adjusted carburettor Low speed jet L Recommended engine speeds are as follows Idle speed, rpm Starter Air ﬁlter Spark plug Adjustment of the oil pumpWhen making adjustments Mufﬂer Heated handles Centrifugal cleaning TurboCooling system Electrical carburettor heating Below you will ﬁnd some general maintenance instructions Daily maintenance Weekly maintenanceMonthly maintenance Technical Data Technical data Length, inches Pitch, inch Max. number of teeth on Bar and chain combinationsBar Chain EN292-2, Cispr 121997, EN608 EC-declaration of conformityApplies to Europe only Page 1088935-26 ´z*xT¶6U¨ ´z*xT¶6U¨