Installing and Operating the Canopy
•With the stroller open, orient the stroller so that you are facing the front side.
•Locate the plastic slide locks on the bottom of each side of the canopy.
•Keeping the canopy closed, orient it so that the apron with the pockets is toward the handle bars.
•Align the plastic slide locks on the canopy with the top of the fittings on each side of the stroller frame. See Figure 9.
•Push each side of the canopy firmly down along the fitting until it cannot go any further.
•Open the canopy by pulling forward on the front edge. Also extend the apron toward the rear of the canopy.
•Attach the side flaps with the hook and loop material just above the canopy fitting on the inside of the stroller seat. See Figure 10.
•Place the rear apron behind the seat back and attach the hook and loop material on each side of the top of the apron to the top of the seat back. See Figure 11.
•Locate the hook and loop straps on each back corner of the canopy.
•Wrap each hook and loop strap around the diagonal frame tube and attach them. See Figure 12.
•Attach the rear of the apron to the top of the seat back using the hook and loop material at the rear center of the apron.
•The canopy and visor can be adjusted into several positions ranging from fully closed to full extended, or any position in between. See Figure 13.
•NOTE that the top rear portion of the canopy has a roll back window. To open, pull the forward edge up, roll the flap back and secure using the elastic loop attachment.
•To close the canopy, push the front edge of the canopy toward the rear of the stroller.
•To remove the canopy, undo all hook and loop attachments. Slide the canopy up off of both fittings on the stroller frame. See Figure 14.
Figure 9 | Figure 10 |
Figure 11 | Figure 12 |
Page 5 | Kooper Instruction Manual |
