Jotul GF300 DV Log Set Installation, Install Right Log, Install Left Log, Install Middle Log

Log Set Installation

Brick Kit Note: Install the optional Antique Brick Kit 155370 before installing the logset. See page 27 and the instructions provided with that kit.

The GF 300 DV logset must be installed before operat- ing the burner. The logset includes four log pieces, packaged inside the firebox, and a quantity of ember stones packaged in the Miscellaneous Parts bag. To install the log set, remove the packaging and place the parts inside the firebox as illustrated in figs 32-36. Do not handle the log set with your bare hands. Always wear gloves to prevent skin irritation from the ceramic fibers.

The ember stones realistically simulate glowing coals when the burner is operating. These should be spread evenly over the burner plate and around the logs. DO

NOT OBSTRUCT THE PILOT ASSEMBLY OPENING. Do not pile up the embers in front ot the burner skirt edges. See fig. 36.

NOTE: You do not need to use all of the ember stones. With experimentation, you will find the arrangement and quantity of embers that works best with your stove. Depending upon the characteristics of your installation, it is possible that too many ember stones can pro- mote sooting on the logs. Adjust the quantity of ember stones as appropriate to maintain the best overall flame picture and burner performance.

THE CERAMIC FIBER LOGS AND GLOWING EMBERS CAN IRRITATE YOUR SKIN. GENTLY WASH YOUR HANDS WITH WARM SOAPY WATER AFTER HANDLING THE LOGS.

Figure 33. Install Right Log

Figure 34. Install Left Log

Figure 35. Install Middle Log

Figure 32. Engage the holes in the underside ot the Rear Log with the two pegs in the burner skirt.

Pilot

Assembly

1/4”	1/4”
6 mm	6 mm

Figure 36. Position embers loosely and maintain 1/4” clearance from the burner skirt edges.

21