Juniper Networks 200 manual Power Fuse

The Rear Panel

Power Fuse

Each NetScreen-200 Series device uses a 2.5 Amp, slow-blow power fuse rated for 250 Volts.

To replace a fuse on a NetScreen-200 Series device:

1.Take the device off-line by turning the power switch OFF and disconnecting the power cable.

2.Using a screwdriver, separate the lid of the external fuse cover from the surface of the power outlet.

3.Gently remove the fuse assembly.

4.Slide the new fuse into the opening until the fuse clicks into place.

5.Replace the power cable, then turn the device power switch ON.

NetScreen-200 Series 7