Juniper Networks 200 manual Ethernet Interfaces, Power Supplies, Rear Panel

Chapter 1 Overview

Ethernet Interfaces

Each Ethernet port is a 10/100 auto-sensing interface with two link LEDs. The left LED indicates network traffic, and the right LED indicates an active network link.

Network Traffic:	Network Link:
Blinking = link activity	On = link is up
	Off = link is down

THE REAR PANEL

The figure below shows the rear panel of a NetScreen-200 Series device (with an AC power supply).

Power Outlet

Power Switch
	Fuse Cover

Note: Certain export restrictions may apply to international customers. Check with your sales representative.

Power Supplies

A NetScreen-200 Series device can have an AC power supply or a DC power supply.

The DC power supply can operate on one or two DC feeds ranging from -36V to -60V. When you use two feeds, they share the load. If one feed fails, the other automatically assumes the full load.

The internal fuse for the DC power supply is a 3.15A/250V, fast-acting fuse. This is not replaceable.

6 User’s Guide