Juniper Networks 200 manual Front Mount, Mid-Mount, Connecting the Power

Connecting the Power

There are two ways to rack-mount the NetScreen-200 Series:

•Front mount

•Mid-mount

Front Mount

To front mount the NetScreen-200 Series device on your equipment rack:

1.Screw the front mount bracket to the side of the chassis.

2.Screw the front mount bracket to the rack, as shown below.

Mid-Mount

To mid-mount the NetScreen-200 Series device on your equipment rack:

1.Screw the mid-mount bracket to the side of the chassis.

2.Screw the mid-mount bracket to the rack, as shown below.

CONNECTING THE POWER

To connect the power supply to the NetScreen-200 Series device:

1.Plug the female end of a power cable into the male power receptacles on the back of the system.

2.Turn the Power switch ON.

NetScreen-200 Series 11