15. CLEANING THE DUAL FROTHER PLUS
Always keep the Dual Frother Plus clean and free of milk deposits. Hardened milk particles will make it impossible to create milk froth.
Fast cleaning:
Display shows READY. Place a cup underneath the frother (Fig.
13)and turn the Steam/Water Selector to the water symbol. Let hot water run through the frother for about 3 seconds and then stop. This will flush out any small milk droplets.
Thorough cleaning of the Dual Frother parts:
•Remove the Dual Frother (Fig. 14) from the Steam Nozzle (Fig. 15c) by pulling down the soft collar of the
•Unscrew the black tip (Fig.14a) from the
•Soak all three parts in hot soapy water.
•Make sure that the two side holes and the channel of the black tip (Fig. 14a) are free of any milk deposits.
Cleaning the Steam Nozzle (Fig. 15c)
•Place a cup underneath the Steam Nozzle (the Dual Frother is off) and let a bit of hot water run through the Steam Nozzle. Tip: If the steam nozzle is blocked by hardened milk, use a needle and loosen up the milk deposit. Then let some hot water pass through the Steam Nozzle.
Assembly of Frother Parts
•Make sure the Steam Nozzle is screwed onto the Metal Tube (Fig. 15a) finger tight.
•Assemble the Dual Frother and make sure that the tip is screwed onto the Connector finger tight (Fig 14a, c).
•Push the black
steam nozzle (the connector should sit flush with the chrome sleeve (Fig. 15b) so that the steam nozzle is no longer visible). Please note: If the parts are not put together tightly it will not be possible to create the frothy foam on top of the milk.
16. CLEARYL WATER FILTER CARTRIDGE
The machine comes with one Water Filter Cartridge. This cartridge is specially made for use with the Impressa E series. The cartridge:
•Reduces the water hardness up to 75%.
•Removes (if present) up to 85% chlorine, up to 90% lead, up to 95% copper and up to 67% aluminum.
•Cleans the water through an upward current principle (Fig. 8) just before the brewing cycle starts, ensuring freshly filtered water every time you make coffee.
•Eliminates decalcifying. When using the water filter cartridge, you never need to decalcify your machine.
•To reorder cartridges see chapter 22 "Supplies".
16a. INSTALLING & ACTIVATING THE CLEARYL WATER CARTRIDGE
Important: Never install the cartridge before or during "Preparing Machine For The First Time."
•Make sure the water tank is empty.
•Remove cartridge from its bag and rinse cartridge under water
•Open water container lid and pull up the holder for the cartridge (Fig.9).
•Insert the cartridge with its tapered end down. Make sure it fits snugly over the white mesh piece inside the water container. Push down gently (Fig.10).
15.
