POWER
FREEZE
NATURAL CINEMA
SWAP
ASPECT
RM-C308
123
INPUT
DISPLAY
BBE
VIDEO STATUS
MUTING
MENU
VCR CHANNEL
PREV NEXT
REC STOP PAUSE
EXIT
V CHIP
789
456
+
CH
VOL VOL
+
CH
PLAY FFREW
SLEEP TIMER
100+
0
RETURN+
LIGHT
TV
CATV
TV/VCR
VCR /DVD
POWER
SPLIT
DVD
VCR
STILL/PAUSE
OPEN/CLOSE
TV
SOUND
21
Remote Control

Install the Batteries

•Before you can operate the remote control, you must first install the batteries (included).
Push down on the remote’s back cover and slide towards the bottom to remove it.
Insert two AA batteries (supplied), carefully noting the “+” and “–” markings on the batteries and on the
remote control. To avoid a potential short circuit, insert the “–” end first. Be sure to use only size AA batteries.
When batteries are installed, slide the cover back into place (until it clicks into position).
•If the remote control acts erratically, replace the batteries. Typical battery life is six months to one year. We
recommend using alkaline batteries for longer battery life.
When you change the batteries, try to complete the task within three minutes. If you take longer than three
minutes, the remote control codes for your VCR, DVD, and/or Cable Box may have to be reset (pages 22-25).

Remote Control Basics

- Press the POWER button to turn the television on or off.
-Make sure the TV/CATV switch is set to TV. Move the switch to CATV only if you
need to operate a cable box.
-Slide the VCR/DVD selector switchto VCR to control a VCR, slide to DVD to control
a DVD player. Please see pages 22 to 25 for instructions on programming your
remote control to operate a Cable box, VCR or DVD player.
- Press the CH+ and CH– buttons to scan through the channels. Tap the CH+ or CH-
button to move through the channels one channel at a time.
- To move rapidly through the channels using JVC’s Hyperscan feature, press and hold
CH+ or CH–. The channels will zip by at a rate of five channels per second.
- Press VOL+ or VOL - to raise or lower the volume. An indicator bar will appear
onscreen to show you the television volume level.
- The CH+/– and VOL+/– buttons are also used to navigate JVC’s onscreen menu sys-
tem.
- You can directly access specific channels using the 10-key pad.
- For more information on remote control button features, see pages 50 to 55. For infor-
mation on using the onscreen menus, see page 26.