JVC CA-MXG950V manual Using the Timers, Using Daily Timer

Using the Timers

There are three timers available — Daily Timer, Recording		On the unit ONLY:
Timer and Sleep Timer.		1 Press CLOCK/TIMER repeatedly
Before using the timers, you need to set the clock built in the
		until “DAILY” appears on the
unit. (See page 10.)
		display.
Using Daily Timer		indicator lights up and DAILY (Daily
		Timer) indicator also starts flashing on the
		display.
With Daily Timer, you can wake to your favorite music or
radio program. You can set the timer whether the unit is on or
off.
How Daily Timer works
The unit automatically turns on, sets the volume level to the
preset level, and starts playing the specified source when the		• Each time you press the button, the timer setting modes
on-time comes (the indicator flashes just before the on-
		change as follows:
time, and continues flashing while the timer is operating).
Then, when the off-time comes (“OFF” flashes just before the				DAILY			ON TIME		REC
off-time), the unit automatically turns off (on standby).							Clock
			Cancelled					ON TIME
The Daily timer works everyday automatically. If you do not
						setting
want to use the Daily timer, turn off the Daily timer. (See “To
					(See page 10.)
turn on or off Daily Timer after its setting is done” on page		2 Press CLOCK/TIMER again.
30.) The timer setting remains in memory until you change it.
•	There is a time limit in performing the following steps. If	“ON TIME” appears for 2 seconds, then the
	the setting is cancelled before you finish, start from step 1
		unit enters on-time setting mode.
	again.
•	To correct a mis-entry while setting the timer, press
	CANCEL/DEMO.

English

Before you start...

•When using a CD as the source to play —

–Make sure there is a CD on the selected disc number tray.

•When using a tape as the source to play —

–Make sure that a tape is in the deck whose deck indicator (A or B) is lit on the display.

–Make sure that the tape direction is correct.

•When using an external component as the source to play

—

–Set the timer equipped on the external component at the same time.

3 Set the on-time you want the unit to turn on at.

1)Turn 4/¢ to set the hour, then press SET/DISPLAY.

2)Turn 4/¢ to set the minute, then press SET/

DISPLAY.

“OFF TIME” appears for 2 seconds on the display, then the unit enters off-time setting mode.

4 Set the off-time you want the unit to turn off (on standby) at.

1)Turn 4/¢ to set the hour, then press SET/

DISPLAY.

2)Turn 4/¢ to set the minute, then press SET/

DISPLAY.

The unit enters source selecting mode.

– 29 –