Creating Your Own Sound Mode
— Manual Mode
You can change SEA pattern to suit your preference. These changed settings can be stored in the MANUAL 1, MANUAL 2, and MANUAL 3 modes.
•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.
On the unit ONLY:
1 Select one of the preset sound modes.
•If you want to add the surround elements in your SEA pattern, select one of the surround modes (D.CLUB, HALL, or STADIUM) before starting the procedure below. (See “Selecting the Sound Modes” on page 10.)
2 Press and hold SET/DISPLAY until “SEA CONT” appears on the display.
4 Press SET/DISPLAY again.
5 Turn 4/ ¢to select one of the MANUAL 1, MANUAL 2, and MANUAL 3 modes into which you want to store the 
SEA pattern.
6 Press SET/DISPLAY again.
The SEA pattern you have created are stored into the MANUAL mode selected in the above step.
Current level appears.
3 Adjust the SEA pattern.
1) Turn 4/ ¢to select the frequency range to adjust (LOW, MID, HIGH).
2)Press 1or Áto adjust the level
3) Repeat steps 1) and 2) to adjust the level of the other frequency ranges.
To use your own sound mode
Select MANUAL 1, MANUAL 2, or MANUAL 3 mode when using the sound modes. See “Selecting the Sound Modes” on page 10.
When you unplug the AC power cord or if a power failure occurs
The setting will be erased in a few days. If this happens, set the manual sound modes again.
– 11 –
