Using Recording Timer
With Recording Timer, you can make a tape of a radio broadcast automatically. You can set the timer whether the system is on or off.
How Recording Timer actually works
The unit automatically turns on, tunes into the specified station, sets the volume level to “VOL MIN,” and starts
recording when the 
indicator flashes just before the
The timer setting remains in memory until you change it.
•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.
•To correct a
CANCEL/DEMO.
On the unit ONLY:
1 Put a recordable cassette into deck B.
2 Press CLOCK/TIMER repeatedly until “REC” appears on the display.
The REC (Recording Timer) indicator also starts flashing on the display.
•Each time you press the button, the timer setting modes change as follows:
DAILY 
ON TIME 
REC
Canceled
Clock
ON TIME
setting
(See page 9.)
3 Press CLOCK/TIMER again.
“ON TIME” appears for 2 seconds, then the unit enters
4 Set the on-time you want the unit to turn on at.
1) Turn 4/ ¢ to set the hour, then press SET/DISPLAY.
2)Turn 4/ ¢to set the minute, then press SET/DISPLAY.
“OFF TIME” appears for 2 seconds, then the unit enters off-
time setting mode.
5 Set the
1)Turn 4/ ¢ to set the hour, then press
SET/DISPLAY.
2)Turn 4/ ¢ to set the minute, then press
SET/DISPLAY.
The unit enters preset station selecting mode.
6 Select the preset station.
1)Turn 4/ ¢to select the band (“TUNER FM” or “TUNER AM”), then press SET/DISPLAY.
2)Turn 4/ ¢ to select a preset channel number, then press SET/DISPLAY.
The REC (Recording Timer) indicator stops flashing and remains lit. The settings you have done are shown on the display in sequence.
7 Press STANDBY/ON | to | STANDBY/ON |
turn off the unit (on standby) | STANDBY | |
if necessary. |
|
|
•If you want to listen to another source while recording Press REC START/STOP or 7 to stop recording. Without stopping it, you cannot change the source.
•Even if you unplug the AC power cord or if a power failure occurs
Once you set the timer, the timer setting may remain stored in memory in a few days. In this case, check whether the timer setting still remains or not.
– 23 –
