JVC CA-MXGT90, CA-MXGT80, CA-MXG70 Using the Timers, Using Daily Timer, Press CLOCK/TIMER again

Using the Timers

There are three timers available — Daily Timer, Recording Timer and Sleep Timer.

Before using the timers, you need to set the clock built in the unit. (See page 9.)

Using Daily Timer

With Daily Timer, you can wake to your favorite music or radio program. You can set the timer whether the unit is on or off.

How Daily Timer actually works

The unit automatically turns on, set the volume level to the preset level, and starts playing the specified source when the

on-time comes (the indicator flashes just before the on- time, and continues flashing while the timer is operating). Then, when the off-time comes (“OFF” flashes just before the off-time), the unit automatically turns off (on standby).

The Daily timer works everyday automatically. If you do not want to use the Daily timer, turn off the Daily timer. (See “To turn on or off Daily Timer after its setting is done” on page 22.) The timer setting remains in memory until you change it.

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

•To correct a mis-entry while setting the timer, press

CANCEL/DEMO.

On the unit ONLY:

1 Press CLOCK/TIMER repeatedly until “DAILY” appears on the display.

indicator lights up and DAILY (Daily Timer) indicator also starts flashing on the display.

•Each time you press the button, the timer setting modes change as follows:

DAILY ON TIME REC

Canceled Clock ON TIME setting

(See page 9.)

2 Press CLOCK/TIMER again.

“ON TIME” appears for 2 seconds, then the unit enters on-time setting mode.

Before you start...

•When using a CD as the source to play —

–Make sure there is a CD on the selected disc number tray.

•When using a tape as the source to play —

–Make sure that a tape is in the deck whose deck indicator (A or B) is lit on the display.

–Make sure that the tape direction is correct.

•When using the external component as the source to play —

–Set the timer equipped on the external component at the same time.

3 Set the on-time you want the unit to turn on at.

1) Turn 4/ ¢ to set the hour, then press SET/DISPLAY.

2)Turn 4/ ¢ to set the minute, then press SET/DISPLAY.

“OFF TIME” appears for 2

seconds on the display, then the unit enters off-time setting mode.

4 Set the off-time you want the unit to turn off (on standby) at.

1)Turn 4/ ¢ to set the hour, then press

SET/DISPLAY.

2)Turn 4/ ¢ to set the minute, then press

SET/DISPLAY.

The unit enters source selecting mode.

– 21 –